Messages

1

General Mach Discussion / Re: X- Box controller

« on: January 04, 2015, 10:47:04 AM »

I tried the same controller with the same results. I then read that it has
to be a Microsoft X-Box controller only. I got one and it works great.

2

Modbus / Re: Modbus Spindle Help

« on: January 04, 2015, 10:33:14 AM »

Oh yea here's my setup for the output to run the on/off.
I was already using a 2nd parallel port and output 1 & 2 to run the VFD
forward and reverse. So you will need to change this setup to meet your
system setup.
Hope this helps, I spent about a whole day on this, I still have not found a
manual for the D100??

3

Modbus / Re: Modbus Spindle Help

« on: January 04, 2015, 10:12:31 AM »

If you want to use on/off control also add the following setup.

4

Modbus / Re: Modbus Spindle Help

« on: January 04, 2015, 10:08:50 AM »

Well I got this to work on my 6040. Here's what I done.
See attached pictures.

5

Newfangled Mill Wizard / Re: Machine Max Limits

« on: December 16, 2014, 09:01:09 AM »

Looks like someone else had the same problem in November but no one replied to that post??
I sure hope I don't have to enter that data every time I load the software???

6

Newfangled Mill Wizard / Re: Machine Max Limits

« on: December 16, 2014, 08:55:44 AM »

That's the same problem I have.

7

Newfangled Mill Wizard / Re: Machine Max Limits

« on: December 15, 2014, 10:23:17 PM »

Thanks Ron I tried that and still it will not save the Machine Max Limits. I have gone as far as editing the ini file still comes up as default settings??

8

Newfangled Mill Wizard / Machine Max Limits

« on: December 15, 2014, 11:25:30 AM »

Am I over looking something? I can not find how to save the Machine Max Limits??
Does this have to be set every time you open the software??
Thanks

9

Newfangled Mill Wizard / Re: MillWizard Exit

« on: December 14, 2014, 06:48:09 PM »

Re-installed Mill Wizard all is good now.

10

Newfangled Mill Wizard / MillWizard Exit

« on: December 14, 2014, 10:12:20 AM »

I have a strange problem. I down loaded and installed Mill Wizard a few days ago and played around with it and no problems. Last night I purchased a License and installed as
per the instructions no problems. When I was ready to exit Mill Wizard it would not close?? I tried to close it with Task Manger and still it would not close. So after a little break I when back to the
shop and was going to work on another project when I opened the new project Mill Wizard close as if I just told it to exit???
So I opened Mill Wizard again and the same, the only way I can exit is after clicking exit and confirming I want to exit, is to try and load another project?
Thanks for any help on this problem.