Messages

1

CS-Lab / Re: incremental encoder 10.000 RPM

« on: January 09, 2015, 05:59:39 AM »

Also should have said, the Enc module itself will not be an issue, the spindle on my Chiron has a max rpm of 3800 and I have an encoder output of 32,768 pulses per rev, so that is  just over 2MHz.
With a 2500 line encoder at 10,000 rpm that would be 1.6MHz.
I think the Enc module can handle at least 3MHz.

Hood

Hi, you say ENC module can handle at least 3MHz.
Can't seem to find this information. How do you know this?
Grtz.

2

General Mach Discussion / Re: Siemens S7-300 PLC & Mach3 system with CS Lab

« on: December 04, 2014, 03:45:10 PM »

What kind of setup in Mach 3 would you recommend?
Setting up serial modbus or TCP modbus?
Which one is the best or the most easy to set up?


Grtz,
Tom.