1
Share Your GCode / Re: Just starting out
« on: November 22, 2014, 11:38:35 AM »
Thanks Gerry
Your not kidding about the learning curve of Autocad. Even with Autocad 2015 for beginners it daunting to say the least. I'm inclined to go with G-Code as you say its much easier to tell the router where to go. After all that's what Autocad is doing anyway. I'll also look at Peter Smid's book.
Thanks for the heads up.
Michael.
Your not kidding about the learning curve of Autocad. Even with Autocad 2015 for beginners it daunting to say the least. I'm inclined to go with G-Code as you say its much easier to tell the router where to go. After all that's what Autocad is doing anyway. I'll also look at Peter Smid's book.
Thanks for the heads up.
Michael.