Hello Guest it is March 28, 2024, 06:05:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - redcell99

Pages: 1
1
FAQs / Re: cant get mach3 to startup on computer
« on: December 06, 2014, 02:55:19 PM »
figured out computer was junk. replaced with another comp, same operating system etc. mach3 loads now.

2
FAQs / cant get mach3 to startup on computer
« on: December 01, 2014, 06:50:08 PM »
I have an issue where i loaded the current version of mach3 software on my computer and the program fails to start. I inserted the xml file for the gecko g540 controller after loading mach3 exe file. when I click on the mach 3 loader (or for that matter any of the other profiles) and select the profile for the gecko controller, the program begins to boot up and the first window appears, it quickly disappears then never loads. no matter what desktop icon I click (mach 3 loader, Mill, Mach3mill) it does the same thing. I uninstalled and reinstalled the software etc and still no luck. I am running windows XP professional  version 2002 service pack 3, 2.80 Ghz Cpu, 960 mb of ram.
any ideas why i cannot get this file to run?

3
FAQs / motors heating and chattering
« on: October 19, 2014, 12:06:41 PM »
I am very new to this and am getting frustrated. I have a 4 axis gecko 540 with 4 stepper motors and a 48v power supply. I have downloaded the mach3 trial version and when I plug my motors in I cant get my Z axis to move at all and the other motors almost vibrate themselves right off the table when I use the keyboard to operate them. They also get hot and make noise while they are sitting idle.
This may not be the right place for this but can anyone help?

Pages: 1