Messages

1

General Mach Discussion / 4th help

« on: March 01, 2015, 02:10:08 PM »

I have a Shizuoka AN-S that I retrofit to MachMotion Mach3 kit a while back. Now I want to retrofit my 4th to be fully interfaced with my controls. Which motor and driver would I want to look at? My 4th is a Yuasa 8" platter.

2

Newfangled Solutions Mach3 Wizards / Re: help with cutting rectangle pocket

« on: October 18, 2014, 07:58:09 PM »

The positive number did the trick on this . Thank you for your help.
 
 

3

Newfangled Solutions Mach3 Wizards / Re: help with cutting rectangle pocket

« on: October 17, 2014, 08:22:33 PM »

A positive number is not doable as I have a circle pocket at the X0 and Y0.

4

Newfangled Solutions Mach3 Wizards / Re: help with cutting rectangle pocket

« on: October 17, 2014, 07:07:41 PM »

I just went out and got a couple screen shots for you to study and tell me what I've done wrong.

5

Newfangled Solutions Mach3 Wizards / Re: help with cutting rectangle pocket

« on: October 17, 2014, 06:45:54 PM »

I was trying to use Newfangled wizard for rectangle pocket.

6

Newfangled Solutions Mach3 Wizards / help with cutting rectangle pocket

« on: October 17, 2014, 05:11:38 PM »

I'm trying to cut a rectangle pocket .687x.500.x.5358 deep. Using a .250 2 flute endmill. When I go to verify tool path it says ERROR-corner rad too large. I have changed tool radius, corner radius to the plus and minus but nothing seems to work. Am I doing something wrong and if so what?