Hello Guest it is March 29, 2024, 08:50:26 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Studioguys

Pages: 1
1
 ;D figured it out, of course the pinout on my table wasn't default at all. I feel like an idiot (but one with a functioning cnc...) Thnx for your trouble Hood!

2
The pinout is default and worked before. The port for dir. is 1, also set default. I'll try different settings, see what happens...

3
Hi guys,

I've had to re-install XP and Mach3. Before the crash, everything worked fine but now after configuring everything, pressing the left and right direction keys sets the mill in motion in the same direction (so both X++) and pressing the X-axis keys causes the mill to move in one and the same direction along the Y-axis. I've checked all the hotkey-settings, motor output settings, pinouts etc. which is basically all standard. What am I missing here?

Thnx in advance for your input!

Cheers,
Rene

Pages: 1