1
General Mach Discussion / Re: Need Help with Set-Up
« on: October 07, 2014, 09:00:27 AM »
Thanks for all the prompt assistance.
After I changed(reversed) the Z setting in the config/homing/limits section and then reversed the Z hot keys everything works great. Test piece cut ran perfect.
Don't understand why I had to reverse the Z setting, however, if it works I'm not going to question.
Thanks for everyone's assistance
Don
After I changed(reversed) the Z setting in the config/homing/limits section and then reversed the Z hot keys everything works great. Test piece cut ran perfect.
Don't understand why I had to reverse the Z setting, however, if it works I'm not going to question.
Thanks for everyone's assistance
Don