1
PoKeys / Re: PoMPG problem to configure in Mach3
« on: September 17, 2014, 02:27:29 AM »
In the manual mentioned earlier there is also a "Analog inputs" section. First I recommend you to check the connections, then calibrate the joystick as mentioned in the manual (it is very simple).
If you look at the analog inputs page of the plugin you can see the voltage measured (it will probably be changing a bit and that causes your axes to move).
To compensate for that start with about 500 in "Deadband" window and than you can lower it. This will remove unwanted jogging as described in the manual.
If you look at the analog inputs page of the plugin you can see the voltage measured (it will probably be changing a bit and that causes your axes to move).
To compensate for that start with about 500 in "Deadband" window and than you can lower it. This will remove unwanted jogging as described in the manual.