Messages

1

General Mach Discussion / Re: Step loss on Mach3

« on: September 12, 2014, 03:27:35 AM »

Hi Roger
I have similar issue. I did not understand what you did to   make steps run correctly. Could you describe more for me? thanks a lot,
Valters

2

General Mach Discussion / when changing direction of any axis one step is continiu to go the same directio

« on: September 11, 2014, 05:37:17 AM »

Hi  ,I.m new to cnc world. I found out that my machine(home made) continue to go one step  forward  when i have pushed already  rewers direction... What can be wrong in my setup, settings.. I'm using MACH 3 .
Thanks,