3
« on: September 09, 2014, 11:30:55 AM »
I am using a new computer with windows 7 64bit had to install a PCI parallel card which loads up in the windows driver giving me an address of E100 - E103. The port tester verifies the E stop port changes state if button is pressed then reset, but runing in mach 3 refuses to acknowledge the card or address. I have tried e100 i both port boxes to correlate with LPT2 or 1 which ever the driver is set to.
Can some one please advise how do I get mack to recognize address/ card.
Checked bios the pci card indicates it is used
Struggling to figure this out.
CNC works on old pc with mother board based parallel port but it has issues hence the new PC
Wisdom please