Hello Guest it is November 27, 2022, 07:11:58 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - amnon

Pages: 1 2 3 4
1
General Mach Discussion / Re: Ref All Home - problem
« on: September 27, 2015, 09:38:43 AM »
Problem solved.

- your limit switches have to be NO
- separate limit switches from Home sewitches

Best Regards
Amnon

2
General Mach Discussion / Re: calculating time
« on: September 22, 2015, 05:01:32 AM »

Thank's Hood

Amnon

3
General Mach Discussion / calculating time
« on: September 21, 2015, 04:19:32 PM »
Hej,

Is there any way(macro maybe) to calculate time of code loaded to mach.

Best Regards
Amnon

4
General Mach Discussion / Re: Ref All Home - problem
« on: September 04, 2015, 12:07:50 PM »
Hi,

I have just changed plugin(I had to separate limit switches from Home sewitches), and homing works fine but when I hit limit switch, push RESET and try move any axis a message shows: Jog function can't be enabled while homing, probing or dwell.

Best Regards
Amnon

5
General Mach Discussion / Re: Ref All Home - problem
« on: September 03, 2015, 02:22:04 PM »
Hi,

I bought this Mach with breakout board in UK.

Best Regards
Amnon

6
General Mach Discussion / Re: Ref All Home - problem
« on: September 03, 2015, 12:43:49 PM »
Hi,

Unfortunately no change. Whats more, I separated limit switches from Home switches, when I Ref All Home only Z axis homing without zeroing axis. Strange.

Best Regards
Amnon

7
General Mach Discussion / Re: Ref All Home - problem
« on: September 02, 2015, 01:13:11 PM »
Hi,

I can't see anythink like filtering/debounce options in plugin Config.
http://ifotos.pl/z/spxnaqr

Best Regards
Amnon

8
General Mach Discussion / Re: Ref All Home - problem
« on: September 02, 2015, 11:18:45 AM »
Hi Russ,

Thank's, I wasn't clear enough, my limits and homing are connected in series and using only 1 pin on USB port. When I do a home move, first the axis Z moves up, hits the home switch then stops and does not backoff. I can see switches still active on the Diagnostic page. Auto limit override is on,  I did try the debounce at 2000 ... no Change.
I have breakout board:
http://www.ebay.co.uk/itm/5-Axis-USB-Controller-Card-400KHz-CNC-MACH3-Mach4-Breakout-Interface-Board-New-/261479889613?hash=item3ce16a7acd

Best Regards
Amnon

9
General Mach Discussion / Ref All Home - problem
« on: September 01, 2015, 01:36:28 PM »
Hej,

I have marked Auto Limit OverRide but when I press Ref All Home it doesn't work.

Best Respect
Amnon

10
Mach4 General Discussion / Re: Spindle turn of mach
« on: July 22, 2015, 10:03:58 AM »
Done - additional filter

Thank's

Pages: 1 2 3 4