Hello Guest it is March 29, 2024, 05:50:43 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 3rdEyeRish

Pages: 1
1
General Mach Discussion / Re: Mach 3 won't load entire g-code?!?
« on: September 06, 2014, 02:35:51 PM »
Nope it's the demo. It's like 2500 lines. Guess I'll have patch in at 2500 sets. ..

2
General Mach Discussion / Mach 3 won't load entire g-code?!?
« on: September 06, 2014, 01:55:52 PM »
My cam software will save it all but when I load it into mach3 it won't have but a 3rd of it.

3
I believe I did try that without any success.  I will Def try that again once I get back home. If anything I may reinstall mach 3 and try it again.

4
I have the driver installed and see it connected under my unspecified devices window as working properly. Green light is lit but not the blue. Idk what im missing!?!?

Pages: 1