Hello Guest it is February 18, 2020, 06:01:05 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Venan

Pages: 1
1
General Mach Discussion / Re: Two 3 axis usb controlles
« on: September 19, 2014, 06:28:59 PM »
After the smootstepper (on port 1-3) what i have to connect - two 3 axis controllers or directly the step drivers?

2
General Mach Discussion / Re: Two 3 axis usb controlles
« on: September 19, 2014, 06:08:00 PM »

3
General Mach Discussion / Two 3 axis usb controlles
« on: September 19, 2014, 05:05:14 PM »
   Hi gys!
It is possible to use two 3 axis usb controlles like this one:
http://www.ebay.com/itm/CNC-USB-Card-3-Axis-MACH3-200KHz-Breakout-Interface-Adapter-/161086021824?&_trksid=p2056016.l4276
to build a 6 axis CNC machine?

Thank you in advance!

Pages: 1