Hello Guest it is March 28, 2024, 04:08:53 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Surfstyle

Pages: 1
1
General Mach Discussion / Re: Driver test failed: APIC seems to fail
« on: August 19, 2014, 10:03:28 AM »
Thank you so so so soooooo much. It works flawles.

2
General Mach Discussion / Re: Driver test failed: APIC seems to fail
« on: August 19, 2014, 01:10:29 AM »
Hello

I'm having a similar problem.

I'm running Mach on 1GHz 512SD RAM Dell Inspirion 4100 machine. The driver test in first two seconds shows normal pulse and then goes of the chart with 8700 pulses/s. When running the stepper motors they are running slow and with lot of interferations.

In BIOS the LPT1 is set to ECP Extended Capability Port, in device manager I've set it to IRQ7. No change.

Does the comp have too little RAM? hmmmm I'm beating my head off this one.

tx

Pages: 1