Hello Guest it is March 29, 2024, 08:18:31 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Zsogol

Pages: 1
1
General Mach Discussion / Backlash absolutely not working!
« on: July 25, 2014, 09:40:15 AM »
Hello!

We purchuased the version number Mach 3 Version R3.043.022 and wanted to adjust the backlash for the ballscrew in the milling machine.
When we configured the program we haven't seen any change in the dial gauge. ( the back movement backlash hasn't been corrected)
First we thought the version is maybe old, so we downloaded the newest one, but neither did it work. So we came here to read about any congifuration options, and everything that we can found we tried. We tried the 50-50-50 properties, little backlash for the axis, to bigger, backlash speed higher to lower, shuttle accel higher to lower even.

Here are the configuration what we have adjusted. Please note that we always used the dial gauge to measure the correction, but the program never corrected it.





Do you have any suggestion that we can do?

Thanks a lot,
Zsogol

Pages: 1