Hello Guest it is March 29, 2024, 10:10:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - marlondave

Pages: 1
1
General Mach Discussion / Re: SPINDLE FREQUENCY?
« on: February 17, 2016, 10:44:35 AM »
I think you may be right Bill, so I'm going to do just that...fingers crossed. :)

2
General Mach Discussion / SPINDLE FREQUENCY?
« on: February 16, 2016, 12:17:41 PM »
I bought and installed a 1.5kw water cooled spindle which is run by a requisite inverter. Now whenever I switch the spindle on it triggers the limit switches and I can't reset it until I switch the spindle off. I'm virtually at a stand-still. Any help? The spindle runs independently of the Mach software by the way.

3
FAQs / Re: SCALE PROBLEMS
« on: July 20, 2014, 03:02:27 PM »
Tweakie, I did like you said, but I went straight to the mach 3 manual to check on the axis calibration. After some tweaking (paradox eh?), I've been able to tune the motors to the right steps, velocity and acceleration I think is suitable for my machine. I'm now up and running with big  :) :)

Thanks a lot, Tweakie  ;D

4
FAQs / SCALE PROBLEMS
« on: July 18, 2014, 12:57:30 PM »
Just bought a new T3020 (chinese) machine and configured it according to the manual. Unfortunately it is cutting about double the size of my uploaded design. The scale is on 1.0000 and in inches which is the format I design in. Tried playing around with the axis calibration but to no avail. Broke three bits already because of too deep Z profiling. I need help please.  >:( ???

Pages: 1