1
Mach4 General Discussion / Re: Mach 4 Bug Reports
« on: September 10, 2014, 11:25:23 PM »
Mach 4 Build 1953
It will not run any older G code file with “A” axis moves. It randomly fails and will not recover without a complete restart. It was running a four hole cycle and it randomly failed on the third hole and never moved again. I setup logging and captured this during multiple runs.
Scott
It will not run any older G code file with “A” axis moves. It randomly fails and will not recover without a complete restart. It was running a four hole cycle and it randomly failed on the third hole and never moved again. I setup logging and captured this during multiple runs.
Scott