Hello Guest it is September 20, 2019, 08:43:26 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - spano

Pages: 1
1
General Mach Discussion / THC Up & Down With 2 Switches?
« on: July 27, 2014, 01:42:14 AM »
Can i use THC up and down with 2 switches?(Ones for Up and Ones for down)
Thanks

2
anyone?

3
hi to all
i am new user for mach3!
please help me to solve this problem:
i config THC from port & pin menu->input signal -> thc up 12 & thc down 13
and config "allow THC Up/Down control even if not in THC mode" in mill option Tabs.
but when the mach3 stop and THC up/down is active, The Z axis is move!
and when mach3 is running Z axis with THC up/down moved but Z DRO Change!

thanks

Pages: 1