Messages

1

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: November 21, 2014, 02:57:41 PM »

Tweekie,
Sorry for the hijack. Digging further I found a charge pump issue disabling the outputs on my PMDX board. Laser works!
Tokamak

2

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: November 21, 2014, 01:52:53 PM »

Tweekie,
Help!!
After reading your build I decided to install an 80W laser on my MechMate. All works fine except turning on the Laser from Mach3.

I cannot get pin 16 to go active. Configured output #1, Port 1, Pin 16

My G code looks like this:

N70G00G20G17G90G40G49G80
N80G70G91.1
N90 (End Mill {0.006 inch}MDF)
N100G94
N110F40.0
N120G00X0.1001Y0.1072M10P1
N130G1M11P1
N140G1Y0.8572M11P1
N150G2X0.1314Y0.8885I0.0313J0.0000
N160G1X0.6314M11P1
N170G2X0.6626Y0.8572I0.0000J-0.0313
N180G1Y0.1072M11P1
N190G2X0.6314Y0.0759I-0.0313J0.0000
N200G1X0.1314M11P1
N210G2X0.1001Y0.1072I0.0000J0.0313
N220G00M10P1
N230G00X0.0000Y0.0000
N240M30
%

Mach3 Ver R3.043.066

I gotta be missing something simple.