Messages

1

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 04, 2014, 04:34:18 PM »

Make SURE that they block the wavelength of your lasers...  not all goggles work at all wavelengths..

Thorlabs LG10, 190 to 534 nm, OD = 7+, they should be fine. We are all very scared by our laser (not the 405nm one), hence the expensive goggles.

2

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 04, 2014, 11:46:30 AM »

Thanks! I will use my lab's goggles, don't worry 

3

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 04, 2014, 04:01:53 AM »

Thank you very much for sharing. Is it against forum rules to ask for your laser source?

4

Show"N"Tell ( Your Machines) / Re: The Laser Project.

« on: June 03, 2014, 05:32:22 AM »

Hi texaspyro, I'm very impressed by your results. Can I ask you how you managed to get such a tight focus? Also, would you recommend your setup to cut ~mm sized features in kapton?