Messages

1

General Mach Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: May 13, 2016, 01:05:36 PM »

take a look here and see if it helps
http://www.ebay.com/itm/CNC-Software-RoutBot-4-Axis-Controller-on-PC-Parallel-Port-for-CNC-ROTARY-TABLE-/181486860756

2

General Mach Discussion / Re: need help please. only one of the three motors work cnc 3020b

« on: January 28, 2015, 12:38:01 AM »

Set up "enable 1"  to pin   14 port 1
Mike Irvin

3

General Mach Discussion / Re: mini cnc computer controlled 3020T DJ 3 Axis router engraver machine

« on: September 22, 2014, 09:25:40 PM »

Here it is

4

General Mach Discussion / Re: HELP...this poor girl is clueless!

« on: September 19, 2014, 03:46:53 PM »

i just sent you an email
Mike

5

General Mach Discussion / Re: HELP...this poor girl is clueless!

« on: September 19, 2014, 03:30:52 PM »

I can help have you set up the machine as per the instructions

6

General Mach Discussion / Re: Heeeeeeeelllllpppp

« on: September 16, 2014, 04:11:09 PM »

Send me the v carve drawing file for the circle you are trying to cut  i will forward it to my friend and he will look at it
Mike Irvin

7

General Mach Discussion / Re: Heeeeeeeelllllpppp

« on: September 16, 2014, 02:31:37 PM »

LostInTranslation  did you get the message i sent you about calling me
Mike Irvin

8

General Mach Discussion / Re: Heeeeeeeelllllpppp

« on: September 16, 2014, 02:21:08 PM »

I think you problem is with v carve settings i am not up on v carve as i use sharp cam and turbo cad i will get a friend who is good with it to try and get you an answer

9

General Mach Discussion / Re: Heeeeeeeelllllpppp

« on: September 16, 2014, 01:47:13 PM »

Is mach3 set to 1.000 on all the scales

10

General Mach Discussion / Re: Heeeeeeeelllllpppp

« on: September 16, 2014, 01:29:59 PM »

set  v carve material setup make sure material is 24 x 24 or larger make sure datum position is set  to  x0 y0  NOT center  make sure  "use offset" is unchecked
Mike Irvin