1
Finished Screens / Re: Mach3 2010 Screenset - Now available
« on: August 11, 2014, 03:44:40 PM »
Thanks for the fast response! After thinking about it, I believe you may be correct with the ajax board not working correctly with the brain. It does state "Z axis is now zeroed" when complete.
I don't think it is a noise issue since it is repeating the same sequence every time.
My hardware has a dedicated Tool Setter Input on the PLC , and the motion controller (MPU11) has a dedicated Probe Input. I currently have it wired into the Tool Setter (which is what i want it to do), but maybe it needs to go directly into the Probe Input. I guess I should find the probe wiring diagram and give it a try.
Thanks again for your help!
Matt
I don't think it is a noise issue since it is repeating the same sequence every time.
My hardware has a dedicated Tool Setter Input on the PLC , and the motion controller (MPU11) has a dedicated Probe Input. I currently have it wired into the Tool Setter (which is what i want it to do), but maybe it needs to go directly into the Probe Input. I guess I should find the probe wiring diagram and give it a try.
Thanks again for your help!
Matt