Hello Guest it is March 28, 2024, 10:41:29 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Joe406

Pages: 1
1
dspMC/IP Motion Controller / Re: DSPMC Mach3 integration issues
« on: April 23, 2014, 09:57:15 AM »
If I lower the I value a little will it speed up the amount of time it settlles on the movement?

Joe

2
dspMC/IP Motion Controller / Re: DSPMC Mach3 integration issues
« on: April 23, 2014, 08:55:10 AM »
Thank you Marc and Rufi for the quick response and all the help yesterday.  Watching you control my pc while talking me through the PID settings on the phone really helped!  I still have a few things to work out but I am in the right direction now.  I will post back if I run into any other issues.

Joe

3
dspMC/IP Motion Controller / Re: DSPMC Mach3 integration issues
« on: April 21, 2014, 04:06:19 PM »
I am working with Rich on this issue.  I have followed the manual regarding the setup of the PID settings.  With the last posted settings I can get about 0.001" of accuracy on the initial move.  When I begin adding D to the setup it doesn't seem to change anything at all other than I seem to have to increase my max following error to allow any move at all.  Is there any other settings I can change that I may be missing?  Basically if I zero everything out and tell the machine to move to 5" it will be 5.001" on the first move.  If I send it to 10" and then back to 5" the results are 4.9895" to 5.0195".  I have started over and followed the manuals procedures multiple times.

Joe

Pages: 1