1
General Mach Discussion / Re: Accuracy and adjustment
« on: May 10, 2014, 05:35:44 PM »
Thanks for all the replies . I've been away and not been able to get on the machine. Very impressed with the level of help, thank you. I think I may of been a bit thick! I bought a couple of new tools and set a new preset in VCarve tried the above suggestions and they're just fine. The tool I was using was a old blunt(ish) thing that came with the machine just marked 'blunt'. I measured the end of the tool (cutting end) this was probably not the thing to do but I had nothing else to go on. It's a steep learning curve for me but it's good to know this forum will offer help when needed.