Messages

1

G-Code, CAD, and CAM discussions / Re: large circles in M3

« on: March 16, 2014, 12:07:28 PM »

That worked! Much thanks Russ and Gerry.

2

G-Code, CAD, and CAM discussions / Re: large circles in M3

« on: March 16, 2014, 10:36:22 AM »

Thanks Russ,

I am not sure I understand what to reverse on the gen config page. Can you point out this setting?

3

G-Code, CAD, and CAM discussions / large circles in M3

« on: March 15, 2014, 01:26:56 PM »

I am just getting started with Mach3. Not sure if this is the right place to post this, but I am having a problem with gcode.

I am using Cut3d to generate cutting paths. When the part is cut on my mill I am seeing big circles, which is not the intent. I can also see these circles in the mach 3 window:




The gcode looks fine when viewed in cutviewer: