Messages

1

Finished Plugins for Download / Re: A new Huanyang VFD plugin

« on: April 14, 2014, 11:38:28 AM »

Good morning.
Excuse my poor English.
I installed the royaumedeole plugin ; It all works, m3, m5,
but the axis motors stops randomly for a few steps.
There are no noise from the spindle. If I put in the manual and I disable the plugin, everything returns to normal.
If I enable the plugin, and I turn off the spindle, the problem returns.
In addition, when the plugin is active, the motors rotate a little slower.
I use the version 1.7.1 of the plugin, and the version 3.043.066 of Mach3.
I even tried to install the vcredist_x86 in French, but nothing has changed.
I also tried .053 and .022 versions of Mach3
I would like to try a previous version of the plugin, but I do not find.
Thanks to those who will find a solution.
giovanni

2

Finished Plugins for Download / Re: Huanyang VFD controller plugin

« on: March 11, 2014, 05:31:39 PM »

Everything OK.
Thanks for the link

3

Finished Plugins for Download / Re: Huanyang VFD controller plugin

« on: March 11, 2014, 01:39:57 PM »

Hello to all.
I searched the forum but did not find.
When I try to configure the plugin Huanyang-rs485, the message "Configuration Screen Are Now Accessed throuth tThe 'Plugin Control Menu'," and do not see the configuration window.
I tried 3 different PCs, and it is always so.
Has anyone had the same problem?.
Thank you, Giovanni