Messages

1

Modbus / Re: Hitachi X200

« on: February 05, 2014, 05:46:46 PM »

which settings are correct??

cambosoup99 settings:


A001- 00
A002 – 02
A004- 400HZ (THIS NEEDS TO BE SET FIRST, BEFORE THE VFD WILL LET YOU CHANGE A003
A003 – 400Hz
A061 – 400HZ
A062 – 0 (THIS THE LOWEST FREQUENCY THAT YOU WANT YOUR SPINDLE TO RUN, YOUR CHOICE, I’M USING 0 FOR FULL RANGE)
A082 – 230V
A151- 0
A152 – 400HZ
A153 – 0
A154 – 100
A155 - 00
B012 – 10 (8 TO 10 AMPS DEPENDING ON YOUR SPINDLE)
H003 – 2.2 KW (this is your spindle kw rating)
H004 - 2 poles


or these ones suggested by diyengineer.


A001 = 03
A002 = 03
B089 = 01
C070 = 03
C071 = 06
C072 = 1
C074 = 00
C075 = 1
C076 = 02
C077 = 0
C078 = 0


I load a Gcode and run it and the VFD doesnt show the frecuency change



thanks

2

Modbus / Re: Hitachi X200

« on: February 02, 2014, 06:36:16 PM »

Hello everyone,

Is necessary the RJ-45 Breakout Board, in this video the guy is using one. http://www.youtube.com/watch?v=x24rP5n0RNw 

thx