Messages

1

G-Code, CAD, and CAM discussions / Re: G-Code Skips From Line 88 to M02 Then Back to Line 88

« on: January 17, 2014, 10:54:38 PM »

Here is one of the files.

Mike

2

G-Code, CAD, and CAM discussions / G-Code Skips From Line 88 to M02 Then Back to Line 88

« on: January 17, 2014, 09:38:22 PM »

Hi and thanks for reading this, I am new to Mach 3.

Title says it all.  I have 6 files of g-code and they all skip from line 88 to M02 (last line of all files) then back to line 88 and continue on normally.  I have reinstalled Mach 3 and that was no help.

All the lines in all the files all look the same so I don't know where to start.

Any ideas?

Mike