Messages

1

General Mach Discussion / Re: verision 3.042.066

« on: May 22, 2014, 03:32:11 PM »

i cant find it on that page

2

General Mach Discussion / verision 3.042.066

« on: May 22, 2014, 08:13:10 AM »

could someone get me the link to this verision 3.042.066
thanks

3

General Mach Discussion / Re: new mach 3 version

« on: February 10, 2014, 11:37:27 AM »

thanks

4

General Mach Discussion / Re: new mach 3 version

« on: February 10, 2014, 11:16:57 AM »

i am using r3042.40 could u tell me what u r using
thanks rod

5

General Mach Discussion / Re: new mach 3 version

« on: February 10, 2014, 11:06:52 AM »

What would u use for miliing?

6

General Mach Discussion / Re: new mach 3 version

« on: February 10, 2014, 11:04:59 AM »

I am using 42 for milling

7

General Mach Discussion / new mach 3 version

« on: February 10, 2014, 10:53:51 AM »

Hi could someone tell me where to go to download the newest version of mach.
thanks for the help Rod

8

General Mach Discussion / Re: RESET MACRO

« on: January 15, 2014, 02:24:40 PM »

Thanks i will look around This is a great site thanks for your help
Rod

9

General Mach Discussion / Re: RESET MACRO

« on: January 15, 2014, 02:13:47 PM »

ok could you give me an idea where the Y axis dir pin might be  as far as the pin ports could you tell me what the assigns should be

10

General Mach Discussion / Re: RESET MACRO

« on: January 15, 2014, 01:59:36 PM »

I did that same results I changed several different keys ,the y axis still goes up with both keys   (up key goes up down key goes uo)  do you have any other ideas?