Hello Guest it is March 28, 2024, 07:15:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Dblc

Pages: 1
1
General Mach Discussion / Re: change computer now issues????
« on: January 09, 2014, 10:07:30 AM »
Thnx for the help.
But I found it .
Macro was not in the folder. It was out for a joyride I guess. Put it back in the folder and
all is good.


2
General Mach Discussion / Re: change computer now issues????
« on: January 09, 2014, 09:09:34 AM »
The only two things that I can think of that will send the axes to a defined position during a toolchange are the actual G Code or a custom M6 macro. If you had a custom macro then you will either have to rewrite that macro or if you have the old computer you may be able to grab it from it.
Hood


I never had a custom macro. The machine always went home on m6 for start and tool change.
I did however go from older to newer software. Maybe something is missing in the new one????
Thnx for the help.

3
General Mach Discussion / change computer now issues????
« on: January 08, 2014, 11:29:33 PM »
Hello.
I have been running my cnc router with mach 3 for a few months now.
Recently I had to replace my computer and now it seems to work but
it dose not go home on m6 for tool change now.
Am I missing something in the software setup?

Any suggestions would be deeply apriciated .
Thnx


Pages: 1