Hello Guest it is October 20, 2020, 09:04:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - jeremy72

Pages: 1
1
General Mach Discussion / Re: Z axis stepper wont move.
« on: December 31, 2013, 05:40:15 PM »
Thanks for getting back to me so fast hood. I got it to work I changed the z to pins 8-9 and it works. this is all new to me. I bought the steppers (nema 23 287oz) BOB is ( DB25-1205) drivers are (DQ542ma). was not getting a signal from 2-3 just thought I would try and it worked. thanks I am sure I will have further questions.

2
General Mach Discussion / Z axis stepper wont move.
« on: December 31, 2013, 02:09:39 PM »
I am new to mach 3 and cnc. I have everything laid out wired up and running except z axis. mach 3 plasma I have x and y movement but when I try z it does not move. I changed drivers and steppers around they all work. Is there a setting I am over looking or not understanding. The DRO I think is what its called is going up and down but nothing at the stepper. thanks ???

3
Hello. I am very new here. My name is Jeremy, I live in Northern California. I am a wood mill crew member by day and a metal hobbiest at home. I am new to mach3 and so far I like it. Building a plasma table right now. But all is new to me. thanks

Pages: 1