1
General Mach Discussion / Re: No motor movement
« on: December 29, 2013, 03:58:31 PM »
I have nema 23 6 wire I'm using a+black a- green b+red b- blue white and yellow not used
the pin # I used off c-10 board x axis pul - 2 dir - 3 in mach I've used step pin 2 drive pin 3 step port 1 dir port 1 and so on
I've soldered and heat shrunk all motor connections
all 4 motors lock up when power is on
the pin # I used off c-10 board x axis pul - 2 dir - 3 in mach I've used step pin 2 drive pin 3 step port 1 dir port 1 and so on
I've soldered and heat shrunk all motor connections
all 4 motors lock up when power is on