Hello Guest it is November 13, 2019, 11:58:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - irobotix

Pages: 1
1
General Mach Discussion / Mach 3 on an older Omax Waterjet?
« on: December 04, 2013, 10:35:17 PM »
Hello.  First post.  I picked up an older Omax 2652 waterjet from a GM auction last week.  It arrived today with the control gutted - no PC or software.  So I am at a point where I either go to Omax and spend roughly $8k on a new PC and software key, or I go another route with Mach 3 potentially.

I can generate G-code from either my 3D HSMWorks CAM, or SheetCAM - I have both.

The unit has Allen Bradley drives - I am not sure of the models - will have to grab that info tomorrow and post it.

It appears to have a special Omax box that is USB that comes from the PC and goes to the drives from there....I would imagine this would not be used with Mach 3?

So - how difficult is it to set up parameters to drive the servo amps / motors using Mach 3?

I am familiar with CNC machining, and robot programming, but have not done a project like this yet...

Thanks in advance!

Pages: 1