Messages

1

General Mach Discussion / Re: Mach3 driver didn't load

« on: November 30, 2013, 10:43:27 PM »

Thanks I ran driver test as administrator and it said a driver loaded
I rebooted and ran test and the driver test screen only shows white screen no little black lines
and the on screen remote doesnt run motors
I loaded road runner and  tryed to run and nothing happened no axis movement even on dro
what should be my next step.
thanks so far
wayne

2

General Mach Discussion / Re: Mach3 driver didn't load

« on: November 30, 2013, 07:49:40 PM »

I did run driver test.exe and it said no driver found
should I wipe the hard drive and reinstall windows 7 32bit again?

3

General Mach Discussion / Re: Mach3 driver didn't load

« on: November 30, 2013, 06:08:18 PM »

I put it into a computer with windows 7 32bit I thought
then I loaded the windows 7 32bit disk and still no driver

4

General Mach Discussion / Mach3 driver didn't load

« on: November 30, 2013, 05:24:16 PM »

I installed a licensed version of mach3 for plasma cnc
it installed fine but it did not ask to load the driver for the printer port.
I loaded the program on 3 other computers and had to remove from 2 because they were compromised
and  the last one crashed as I was setting up mach3

Is there a computer limit that I may have reached?
the mach3 program works but no driver.
thanks for help
wayne