Hello Guest it is March 28, 2024, 07:11:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - joea

Pages: 1 2 »
1
General Mach Discussion / Re: how to: wizards
« on: August 05, 2017, 12:55:09 PM »
There is so much to learn. This is like pealing an onion. all I want to do is a few simple   procedures
I am going to be a perpetual student.

....  joe

2
General Mach Discussion / Re: how to: wizards
« on: August 05, 2017, 10:12:09 AM »
is the source code of any of the wizards .i.e cut circle;  available?
are the wizards propriety or open-source?

.... joe

3
General Mach Discussion / Re: how to: wizards
« on: August 04, 2017, 07:19:53 PM »
thanks Gerry; you are a wealth of info.

..... joe

4
General Mach Discussion / how to: wizards
« on: August 04, 2017, 12:24:57 PM »
I would like to  write a wizard for mach3. how and where to look?
 some say;  there is a how-to in mach2 folder; can not find it.
 any examples anywhere?
 any suggestions ?

....     joe

5
Tweakie;
your words must be magic. I retried the download after your response and it worked. prior to that I must  have tried it 10 times with no effect.

...... thanks,    joe

6
help: How can I download the .062 version?

...  joe

7
I cannot down load the .062 version.; system goes into infinite loop.

.... joe

8
General Mach Discussion / Re: usb to printer port
« on: July 19, 2017, 08:46:46 AM »
just thinking. Can generated g-code be placed in the cloud i.e. Google drive and then run on the mach3 machine?

....joe

9
General Mach Discussion / Re: usb to printer port
« on: July 19, 2017, 07:12:11 AM »
Yes I know about the fusion 360 restriction. The plan now is to use a 64bit laptop for design and cam. Then move the g-code to the mach3 machine; is that doable?
Is a post processor necessary or available?
How are people doing this?
I found a computer shop locally that will replace the xp system with win7 32bit; I'll bring the computer there today.

.....joe

10
General Mach Discussion / Re: usb to printer port
« on: July 18, 2017, 08:17:54 AM »
originally I had a system win7 32bit, but I upgraded this machine to 64bit   so I could use fusion 360; but then could not use mach3. It seems I do everything wrong first before I get it right . In my local I can not find a win7 32bit with parallel port.
I did find a xp with pp but that won't let me load fusion 360.

I want a virgin system as a base  product as a comparison for future systems, i.e. ucc, grbl, etc.
Is there anywhere I can download a valid legal win7 32bit product?

...joe

Pages: 1 2 »