Messages

1

General Mach Discussion / Re: No Output Voltage from Leadshine MX3660/ UC100

« on: December 05, 2013, 11:31:33 AM »

The problem was that Leadshine did not explain in their installation manual that the output leads were just for switching and that an additional power source (<24 VDC) must me provided. They have now modified their manual and provided me with the correct wiring diagram to attach the relays.

Leadshine was VERY helpful, Cnc4pc the exact opposite.

2

General Mach Discussion / Re: No Output Voltage from Leadshine MX3660/ UC100

« on: November 26, 2013, 03:22:05 PM »

Yes, I have and everything within Mach 3 looks fine. I have added my motors and tuned them with no problem.

3

General Mach Discussion / No Output Voltage from Leadshine MX3660/ UC100

« on: November 20, 2013, 09:04:43 PM »

Hi Guys,

I'm new to this whole PC based CNC control stuff,but not to CNC (I've owned a CNC shop since 1983!). I have connected my laptop (running Mach3) via USB to a UC100 then into a Leanshine MX3660 3-axis drive. Everything have been configured correctly and I get no faults on the diognistics page and everything is correct on the UC100 in/out moniter... But I get no output voltage in any of the 4 output sets when the M3, M4, M7, M8 toggles are actuated. I also have the Pulse LEd enabled.

Am I doing something wrong or do i have a bad MX3660???

Thanks in advance for your help!