Hello Guest it is May 30, 2024, 02:15:39 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Lloyd

Pages: 1
1
General Mach Discussion / Editing Gcode question
« on: June 30, 2017, 07:35:38 AM »
After saving my Crv files in Vcarve Pro and changing it into text files for Mach3-I have one letter on my engraving project that is not cutting deep enough. How do I edit the text files in Mach 3 and how do I know the exact ones to edit to allow the engraving to cut deeper on just that letter?  Thank you! 

2
Is there a lower cost alternative Digital Step  drive that works like the Gecko G540?   I understand though you get what you pay for.  Thanks!

3
I am new to the CNC hobby.  Is there anyone who lives near zip code 18969  Telford/Souderton Pennsylvania.  Am looking to ask questions about Mach3, learn and hopefully that person can stop by and check my CNC system.  I am disabled and could use some help.  I will gladly pay for your time.  I can be reached at 215-721-9555   Thanks!

4
General Mach Discussion / New to CNC Setting up today Y axis question
« on: November 06, 2013, 05:33:00 PM »
  CNC set up and jogging great on X & Z axis.    Y axis  jogs just a few inches then stops and red light comes on the driver.  I am running 2 stepper motors on the Y axis with a G540 Gecko Driver.  When I turn the power supply off and back on again-Y axis jogs a few inches and stops again with the red light.  Can you point me in the right direction on what I should checking?  Thanks!

Pages: 1