1
General Mach Discussion / Re: spindle shuts off right after start ("limit switch tripped")
« on: October 08, 2013, 01:05:21 AM »
Hood,
Thank you for getting back to me so quickly. I will try that but I am quite certain that is the problem. I had made an extension to the trigger switch wire for the z axis and I used unshielded wire not knowing that was necessary. Without changing the wire I am already getting a better response from changing the Debounce. I'll respond again once I test it the new wiring.
Matt.
Thank you for getting back to me so quickly. I will try that but I am quite certain that is the problem. I had made an extension to the trigger switch wire for the z axis and I used unshielded wire not knowing that was necessary. Without changing the wire I am already getting a better response from changing the Debounce. I'll respond again once I test it the new wiring.
Matt.