Messages

1

General Mach Discussion / Re: spindle going the wrong way

« on: September 24, 2013, 02:27:35 PM »

hi thanks for your help peter/hood all working fine now thanks to you two 

2

General Mach Discussion / Re: spindle going the wrong way

« on: September 24, 2013, 05:44:21 AM »

Hi Hood i thick that would be might be quicker for me to do that but there is 3 wires that come out of the unit so which ones do i swoop over cos knowing my luck i move the wrong cable and blow the lot up the way my luck going lol thanks Tom
 

3

General Mach Discussion / Re: spindle going the wrong way

« on: September 23, 2013, 06:44:35 PM »

Hi hood thanks for the info but to be honest with you i dont know alot about  modbus i just control it with the control knob on the vdf unit i want to set it up so mack3 can control it but i not sure what to do that thanks

4

General Mach Discussion / spindle going the wrong way

« on: September 23, 2013, 03:47:16 PM »

Hi me again i have sorted all the other problems out that i have had  and now what the problem is the spindle going the wrong way round !!!! i am using mack3 and xinfutai vfd‏ inverter i am controling the spindle by this. so when i turn the control knob it gos the wrong way please can someone help before i go mad thanks Tom

5

General Mach Discussion / mack3 licence ?

« on: September 23, 2013, 04:12:31 AM »

hi i got mack3 which i got in janurary and the licence.i had to reinstall mack3 over the week end and downloaded mack3 of the web site and then put my licence in the folder and installed it.but now it justs come's up with demo.could anyon e help me out on this one many thanks Tom

6

General Mach Discussion / help with setting up spindle with mack3

« on: September 20, 2013, 05:03:56 AM »

Hi can someone please help me to setup my mack3 to control  my spindle i have a Xinfutai VFD to control it the spindle but i have not got a clue how to setup the software many thanks to you if you can help Tom

7

General Mach Discussion / help please setting up Xinfutai VFD‏

« on: September 19, 2013, 05:54:25 PM »

Hi can someone please help me set up my Xinfutai VFD‏ unit to run with mack3 and control my spindle i am quite new to this so if someone can help me please thanks