Hello Guest it is April 19, 2024, 09:21:23 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - andros

Pages: 1 2 »
1
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 26, 2013, 07:04:08 PM »
I figured it out!!!! It was in Ports and Pins. I needed to tick Step Low Active in the Y-axis. Bingo.

2
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 21, 2013, 06:04:56 PM »
Just to confirm: my xml is weird and by recreating it from scratch might fix it?

3
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 21, 2013, 05:54:35 PM »
Love you man! Cant wait to test it out! Really appreciate your help!!! Ill test it out as soon as i get a new PSU. Ill post my results! Thank you so much!!!

4
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 21, 2013, 03:08:56 PM »
Could it be the gecko. If you could check the ports for me i would be really appreciative. Thanks for helping me so far!

5
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 21, 2013, 03:05:15 PM »
Thank you Hood. Meanwhile the power supply to the g540 blew up. Great. I will try as soon as i get a new one! Whats weird is that motor x and y are the exact same and it sort of works in backlash mode. Could it be a software bug?

6
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 21, 2013, 08:34:27 AM »
Hey Hood.

Sorry i missed your post! I havent tried to set it up like you describe. But the dros are counting when hitting the up and down arrow keys in step mode but the motors are not moving. Did you check my video? Weird how it sort of works in backlash comp mode huh?

7
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 20, 2013, 06:50:09 PM »
It runs on a standalone computer connected via printer port to an external gecko drive g540.

8
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 20, 2013, 05:17:11 PM »
yes. no difference unfortunately.

9
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 20, 2013, 03:11:46 PM »
Hey Hood!

Here is a video I recorded of the super weird problem I have:
http://www.youtube.com/watch?v=GWKeM4iC-Pw

Attached is the XML


Looking forward to your answer

10
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 19, 2013, 01:42:36 PM »
Thank you. Will send it to you tomorrow. Im desperate so i will look for you email every second. I reallllly appreciate you taking the time to help me!

Pages: 1 2 »