Messages

1

General Mach Discussion / Re: X AXIS OFFSET

« on: March 24, 2016, 10:45:41 AM »

 greetings all...
can anyone help in my problem .. I really appreciated your comment

2

General Mach Discussion / Re: X AXIS OFFSET

« on: March 23, 2016, 02:53:56 AM »

aim using these stepper moto

3

General Mach Discussion / Re: X AXIS OFFSET

« on: March 23, 2016, 02:37:48 AM »

and this is my motor tunning set up..
it is same value tunning on x,y,z axis

4

General Mach Discussion / X AXIS OFFSET

« on: March 23, 2016, 01:53:19 AM »

hai...
i have made my cnc home made ..my problem is x axis still having problem that is not center on my work pieace..
i have do axis calibration but the problem still not resolved.

5

General Mach Discussion / Re: need Help on Ref all home

« on: December 25, 2015, 11:07:21 PM »

Ok thanks......

6

General Mach Discussion / need Help on Ref all home

« on: December 23, 2015, 03:28:31 AM »

Hai... all..
Aim new on cnc mach3.. need help on my ref all home button. when push ref all button X,Y,Z axis run very slow to ref point..
How to adjust that feed rate  ref all home ?

7

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: September 18, 2013, 12:25:13 PM »

hi.. all.. aim sany from malaysia..  new in cnc world.. making my cnc by aluminium profile...   I have been using Mach3 for a few week. i have some problem on it...

8

General Mach Discussion / Re: please help having problem with mach3

« on: September 18, 2013, 12:35:29 AM »

Sounds like you have the acceleration rate too high and the axis is loosing steps somewhere. Try lowering the accel rate by 1/2 and retest. If it fixes it then increase it until problems show up then back it down until they go away.

(;-) TP

tq ... for reply...  if acceleration rate to high , isit possible only x axis offset ?...

9

General Mach Discussion / please help having problem with mach3

« on: September 17, 2013, 11:16:00 AM »

hai .... i'm new user on mach3
I faced the problem where when I run the program on beginning at zero point and at the end of the program he will return to the zero point. but I found the tool I'm not at the zero point. but the x axis offset to the left of 1.5mm. y axis zero point. why x axis offset when Mach3 DRO shows COORDINATE X0.0 Y0.0 Z0.0?

but when I run a program that does not have a radius. at the end of the tool will return a zero point in the right circumstances.