Hello Guest it is March 29, 2024, 05:55:43 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bollga

Pages: 1
1
General Mach Discussion / Re: Mach3, servos and no motion controller
« on: August 14, 2013, 02:44:29 PM »
I'm also very interested in this topic.
I'm hoping to use linear encoders.

I understand that backlash will throw a monkey wrench into the system, but let's say for the sake of argument that there is no backlash in the system.

If I set Mach3 to move 1000 steps per mm and I enter G-code to move an axis 1mm at a certain feed rate.
The servo driver will get 1000 step commands at the set feed rate, correct?
Will the servo driver verify through linear encoders that it has move the 1mm specified by 1000 steps?

Hoping I can either verify this before dropping coin on upgrades.

Thanks for any input.

Pages: 1