Hello Guest it is November 21, 2019, 11:45:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bh

Pages: 1
1
General Mach Discussion / Re: cant get my table to respond
« on: August 13, 2013, 08:37:21 AM »
thanks hood!  i see you on all the time and was hopin you wld respond..  cld my "flow" be an issue?  im pretty shure its a hardware issue, port problem?  will send you my stuff, thanks again 4 your time!!!!  brian

2
General Mach Discussion / cant get my table to respond
« on: August 12, 2013, 11:21:08 PM »
hi guys or gals i need some help...  i bought a table a few years ago and had it up and running fine. i never really cut any thing with it,was in the middle of building a new house.. im done with the house and im ready to run this.  bought a new computer for the table and cant get it to move...  my screen shots are the same as before, but i think i have a parallel port issue. tried a new one that was listed on this site, no luck!   i can turn the spindel  on and off but that is all.  seems i remember something abt flow,not shure if that is an issue!   im located in northern illinois,anyone close that i cld pay to come help me out a lil... thanks 4 days of messing w it and im getting a lil crazy.... brian

Pages: 1