Guest
Show Posts
1
General Mach Discussion / Re: "a sharing violation occurred while accessing an unnamed file"
« on: July 06, 2016, 06:06:48 PM »
For people that just want to install Mach 3 to "learn" and are not worried about conflicts: There is a work-around..
As the "a sharing violation occurred while accessing an unnamed file" is a standard error that means that two programs can not handle the same file at the same time; and irsetup is trying to access a file that is currently in use.
Solution Windows XP: Click Start: Run: and Type " msconfig " no quotes then click the ok button
In the default GENERAL tab of the SYSTEM CONFIGURATION UTILITY: Click the radio selector dot to select: Diagnostic Startup
This will disable programs that may have accessed the UNNAMED file when the computer is restarted. Click OK, then click the restart button
After the computer restarts... there will be a message... leave it there and ignore it for now...
Now that your ANTI-Virus and other programs are not running you should be able to install the Mach 3 Program
1. Install Mach 3
2. If it doesn't install, then try to install as administrator
When I did this, I did receive an error that the port was not found... this is not an issue for those that are learning.
Then after the Mach 3 install ... return to the SYSTEM CONFIGURATION UTILITY: and click Normal Startup... Apply and Ok
After the reboot...
Now... your computer has access to whatever that unnamed file was... so you can simply
One last time Install MACH 3 ... and it should install without any error and install the port with no errors.
P.S. All the information above does matter... but this is for those that just want to LOOK at the program try it a couple of time
to see if the program even works on their computer... if it works.. and you want to run a machine with the computer..
Then all the advice above is both noteworthy and recommended... I hope this helps someone... take care
To the admins... this is a old topic... and the solution should be applied here... as this is were everyone ends up that searches this issue.
As the "a sharing violation occurred while accessing an unnamed file" is a standard error that means that two programs can not handle the same file at the same time; and irsetup is trying to access a file that is currently in use.
Solution Windows XP: Click Start: Run: and Type " msconfig " no quotes then click the ok button
In the default GENERAL tab of the SYSTEM CONFIGURATION UTILITY: Click the radio selector dot to select: Diagnostic Startup
This will disable programs that may have accessed the UNNAMED file when the computer is restarted. Click OK, then click the restart button
After the computer restarts... there will be a message... leave it there and ignore it for now...
Now that your ANTI-Virus and other programs are not running you should be able to install the Mach 3 Program
1. Install Mach 3
2. If it doesn't install, then try to install as administrator
When I did this, I did receive an error that the port was not found... this is not an issue for those that are learning.
Then after the Mach 3 install ... return to the SYSTEM CONFIGURATION UTILITY: and click Normal Startup... Apply and Ok
After the reboot...
Now... your computer has access to whatever that unnamed file was... so you can simply
One last time Install MACH 3 ... and it should install without any error and install the port with no errors.
P.S. All the information above does matter... but this is for those that just want to LOOK at the program try it a couple of time
to see if the program even works on their computer... if it works.. and you want to run a machine with the computer..
Then all the advice above is both noteworthy and recommended... I hope this helps someone... take care
To the admins... this is a old topic... and the solution should be applied here... as this is were everyone ends up that searches this issue.
?