Hello Guest it is March 29, 2024, 03:58:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Zeph

Pages: 1
1
Thanks-  I was able to finally get an old notebook to drive it properly, so my desire to start from scratch has faded.

But it's still on my list of things to do someday. 

2
A very old thread, but has anyone heard of this being done?  I've just spent days trying to get the software for a 98-Z to run, and it is very unstable on my PC.  No software updates are available for this plasma table from PlasmaCAM. They still have parts, but don't support it in the newer software.

I'm so frustrated with it I'm considering ripping out their control box, and going au-natural....  Two DC motors with encoders, one stepper, and four limit switches (X, Y, Z-up, Z-down).  That's it.


Pages: 1