Hello Guest it is May 18, 2021, 04:57:08 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gavna77

Pages: 1
1
General Mach Discussion / Re: No Y axis movement from G code
« on: July 28, 2013, 02:23:51 PM »
Ok thanks Hood,

The drilling section of the 'test' file is fine but cutting out the square doesn't happen. The 'x' axis moves fine but the 'y' axis doesn't move at all. Although it shows moving on the dro.

Cheers,
Gav

2
General Mach Discussion / No Y axis movement from G code
« on: July 28, 2013, 11:58:45 AM »

Hi All,
I hope you can help!

I don't seem to have any Y axis movement when i run a program to cut.
I can jog and everything works and even run a drilling program and everything works but when i run a cutting program the head will move to the correct starting poiint using x,y and z axis but then wont move the y axis when cutting?

Thanks in advance
Gav

Pages: 1