Messages

1

General Mach Discussion / Re: How to set up OEM LED IN MACH3?

« on: July 09, 2013, 04:53:52 PM »

it sounds ok , but for my level on VB and Brain writeing might sound too much, can you plese give me some hints or some links to learn that? Romanian forums do not cover that.

2

General Mach Discussion / Re: How to set up OEM LED IN MACH3?

« on: July 09, 2013, 03:18:52 PM »

OK. Thank you:))I've learned something today.I have tried it and it works:P but it stops only with E-stop

But how do I make it without macros, I wanna do it by useing the OEM led codes, for others signals,and where can I find tutorials for doeing so?
 
Thank you again!

3

General Mach Discussion / How to set up OEM LED IN MACH3?

« on: July 09, 2013, 09:39:29 AM »

Hello,

Can anyone please help me , how to configure OEM LED in mach3, I whant to light up an LED when the M30 comand apperars, to have a signal when the program has ended.
I haven a secound printer port enabled and i whant to get a ''1 logic'' when the program has ended.
I saw that in OEM LED Code list there are codes that emulates that state burt I can not find where to put that code say:, output 3 enabled pin 14 port 2 when M30 is shown, I gues that there is a method to do that not only for what I wand but for other functions that Mach can light a LED Output say: (spindle running) useing the OEM Led code list

Thank You!