1
General Mach Discussion / Mach3 Problem
« on: December 16, 2014, 07:40:07 PM »
Video what happen>> http://screencast.com/t/RVH9sgnoJN
I send this here too ,i hope to get help,and answer..
In this video with two stop, and then hold depressions feed, after which the start,
Why it starts to turn the A-axis.
There is not any command to the A-axis.
Kai
I send this here too ,i hope to get help,and answer..
In this video with two stop, and then hold depressions feed, after which the start,
Why it starts to turn the A-axis.
There is not any command to the A-axis.
Kai