Messages

1

G-Code, CAD, and CAM discussions / Re: Emachine shop drawing to D2nc cam to Mach3

« on: October 30, 2015, 02:18:50 PM »

 Rich, I've done quite a bit of cnc machining that I programmed right at the machine (mostly Fadal ) with G codes
 but I've never had any dealing with cad programs until now. Guess it's time to step into the 21st century, thanks a heap, Jerry

2

G-Code, CAD, and CAM discussions / Emachine shop drawing to D2nc cam to Mach3

« on: October 29, 2015, 02:29:13 PM »

Hi to all, I'm new to all 3 of these programs and I don't have much hair left to pull out so I hope someone can help me figure out the process to download a drawing from E machine  to D2nc and then to mach3.
Thanks a heap for any help, Jerry

3

General Mach Discussion / setting up the surfacing wizard

« on: September 22, 2014, 09:28:37 PM »

Hi I'm new to the mach3  and the wizards. the problem I'm having is when I input the clearance of .100 and final depth of .01 and depth of step at .001 the code says that it takes 2 passes at .005 rather than 1 pass at .01 what am I missing?