1
Mach3 under Vista / Re: configuring mach3 with vista and running on pci card for motion controller.
« on: May 31, 2013, 10:08:11 AM »
thanks for the reply,
i have tried doing that but still with no luck. i have since found out that it may be due to my system is running at 63bit, and so i have been told mach3 does not support this and will only run on 32bit. i think a new pc is in order here.
thanks for your assistance.
i have tried doing that but still with no luck. i have since found out that it may be due to my system is running at 63bit, and so i have been told mach3 does not support this and will only run on 32bit. i think a new pc is in order here.
thanks for your assistance.